Laboratory swivel swan neck mixer hot and cold water tap school or commercial

Product Description:

Swivel swan neck mixer tap , aerator
Brass construction
Plastic coating Rilsan
Light grey as standard

Water supply:
This should be of high enough pressure to operate science equipment. The supply should be controllable
(e.g. with pressure reducer) for emergency eyewashes. To prevent waste water contaminating the incoming water supply, an air gap at the point of entry to lab, usually using a header tank should be provided, with an electric pump to maintain pressure if needed.
Note: Most school science labs should comply with The Water Supply (Water Fittings) Regulations 1999, fluid category 4, concerning fluid which represents a significant health hazard due to the concentration of toxic substances.

H PATTERN MIXER TAP WITH MOVABLE SWAN NECK AND AERATOR NOZZLE
Description
THE ‘H’ PATTERN MIXER TAP HAS AN AERATOR NOZZLE TO REDUCE SPLASH BACK BY INTRODUCING AIR INTO THE FLOW OF WATER. THE TAP IS MADE OF BRASS CONSTRUCT WITH A RILSAN COATING, THE CENTRES ARE 178MM AND BOTH HOT AND COLD INLETS ARE 1/2″ MALE BSP.

AS AN EXAMPLE, THESE ARE IDEALLY SUITED TO A SCHOOL ART ROOM.

WRAS APPROVED.

THERE ARE A COUPLE OF ALTERNATIVES TO THE STANDARD PRODUCT WHICH ARE ILLUSTRATED IN THE PRODUCT GALLERY:

1) AS ABOVE WITH FIXED SERRATED NOZZLE

2) AS ABOVE WITH REMOVABLE NOZZLE